Montesa COTA 4RT 260 2023, Owner'S Manual

Page: 148 / 180

5-23 5-23
Frame servicing
(1) SHOCK ARM PLATES-TO-SWINGARM BOLT/NUT
(2) SHOCK ABSORBER LOWER MOUNTING BOLT/NUT
Install the following:
– Shock arm plates-to-swingarm bolt/nut
– Rear cushion lower mounting bolt/nut
Tighten the shock arm plate bolt.
Torque: 39 N•m (4.0 kgf•m, 29 lbf•ft)
Tighten the shock absorber lower mounting bolt to the
specified torque.
Torque: 39 N•m (4.0 kgf•m, 29 lbf•ft)
Install the rear wheel (page 5-15)
(1) CALIPER
(2) BOLTS
(3) DISC COVER
(4) PAD SPRING PIN
(5) PAD PIN
Brake pad replacement
Clean the brake disc with a high quality degreasing agent
if they are contaminated with oil or grease.
Replace the pads if they are contaminated.
Front Brake Pad Replacement
Loosen the pad pin.
Remove the spring pin from the pads.
Remove the brake caliper mounting bolts, disc cover,
flange collars and caliper.
Push the pistons all the way in to allow installation of new
brake pads.
Check the brake fluid level in the reservoir as this operation
causes the level to rise.
Remove the pad pins and brake pad.
Clean the brake caliper inside especially around the caliper
pistons.
1
2
1
3
4
5
2
2