Monterey Boats 350 Sport Yacht, Owner'S Manual

Page: 100 / 196

350 SPORT YACHT
100
Note: Storms and wave action can cause
buoys to move. You should not rely on
buoys alone to determine your position.
12.3 Pre-Cruise Check
Before Starting the Engines:
• Check the weather forecast and sea conditions
before leaving the dock. Decide if the planned
cruise can be made safely.
• Be sure all required documents are on board.
• Be sure all necessary safety equipment is on
board and operative. This should include items
like the running lights, spotlight, life saving
devices, etc. Please refer to the Safety
Equipment chapter for additional information
on safety equipment.
• Make sure you have signal kits and flare guns
aboard, and they are current and in good
operating condition.
• Be sure you have sufficient water and other
provisions for the planned cruise.
• Leave a written message listing details of your
planned cruise with a close friend ashore (Float
Plan). The float plan should include a
description of your boat, where you intend to
cruise, and a schedule of when you expect to
arrive in the cruising area, and when you
expect to return. Keep the person informed
of any changes in your plan to prevent false
alarms. This information will tell authorities
where to look and the type of boat to look for
in the event you fail to arrive.
• Check the amount of fuel on board. Observe
the “rule of thirds:” one third of the fuel for
the trip out, one third to return and one third
in reserve. An additional 15% may be consumed
in rough seas.
• The engine fuel filters should be checked for
leaks or corrosion.
• Turn the battery switches on.
• Check the bilge water level. Look for other
signs of potential problems. Monitor for the
scent of fuel fumes.
• Test the automatic and manual bilge pump
switches to make sure the system is working
properly.
• Turn on the bilge blower. Check the blower
output and operate four (4) minutes before
starting the engine. The blower also should
be activated when operating below cruising
speed and when operating the generator.
• Have a tool kit aboard. The kit should include
the following basic tools:
Spark plug wrench Hammer
Spark plug gap gauge Electrician’s tape
Screwdrivers Offset screwdrivers
Lubricating oil Pliers
Jackknife Adjustable wrench
Basic 3/8" ratchet set Vise grip pliers
Hex key set Needle nose pliersW i r e
crimping tool Wire connector Set
End wrench set Medium slip-joint pliers
Diagonal cutting pliers DC electrical test light
THERE MUST BE AT LEAST ONE PERSONAL
FLOTATION DEVICE ON BOARD FOR EVERY
PERSON ON BOARD AND ONE THROW-OUT
FLOTATION DEVICE. CHECK THE U.S. COAST
GUARD STANDARDS FOR THE CORRECT TYPE
OF DEVICE FOR YOUR BOAT.
• Have the following spare parts on board:
Extra light bulbs Spark plugs
Fuses and circuit breakers
Main 12-volt fuses Assorted stainless screws
Assorted stainless bolts Flashlight and batteries
Drain plugs Engine oil transmission
oil Propellers
Propeller nuts Fuel filters
Fuel hose and clamps Wire ties
Engine cooling pump Hydraulic oil
impeller Kit Assorted hose
clamps Rags
Steering fluid Pump & alternator belts
• Make sure all fire extinguishers are in position
and in good operating condition.