ABOARD – On or in the boat.
AFLOAT – On the water.
AFT – Toward the rear or stern of the boat.
AGROUND – Touching bottom.
AMIDSHIP – Center or middle of the boat.
ANCHOR – (1) An iron casting shaped to grip the lake bottom to hold the boat. (2) The act of setting the anchor.
ASHORE – On the shore.
ASTERN – Toward the stern.
BAIL – To remove water from the bottom of the boat with a pump, bucket, sponge, etc.
BAITWELL – A miniature livewell used to store and keep live bait alive and healthy.
BEAM – The widest point on the boat.
BEARING – Relative position or direction of an object from the boat.
BILGE – The lowest interior section of the boat hull.
BILGE KEELS – The raised areas or aluminum extrusions on the bottom of a boat that parallel the keel.
BOARDING – To enter the boat.
BOUNDARY WATERS – A body of water between two areas of jurisdiction; i.e., a river between two states.
BOW – The front of the boat.
BULKHEAD – Vertical partition (wall) in a boat.
BUNKS – Carpeted trailer hull supports.
BURDENED BOAT – Term for the boat that must “give-way” to boats with the right-of-way.
CAPACITY PLATE – A plate that provides maximum weight capacity and engine horsepower rating information. It is
located in full view of the helm.
CAPSIZE – To turn over.
CAST-OFF – To unfasten mooring lines in preparation for departure.
CENTER LINE – A lengthwise imaginary line which runs fore and aft with the boat’s keel.
CHINE – The point on a boat where the side intersects (meets) the bottom.
CLEAT – A deck fitting with ears to which lines are fastened.
CONSOLE – Also called helm. The steering wheel area of the boat.
CRANKING BATTERY – The main battery used for engine starting and electrical circuits.
CURRENT – Water moving in a horizontal direction.
DECK – The open surface on the boat where the passengers walk.
DEEP CYCLE BATTERIES – Special long-running batteries which can be repeatedly discharged and recharged
without significant loss of power.
DOLLY WHEEL – A rolling jack assembly at the front of the trailer used for positioning the coupler during trailer
hookup.
DRAFT – The depth of the boat below the water line, measured vertically to the lowest part of the hull.
ELECTROLYSIS – The break-up of metals due to the effects of galvanic corrosion.
FATHOM – Unit of depth or measure; 1 fathom equals 6 feet.
FENDERS – Objects placed alongside the boat for cushioning. Sometimes called bumpers.
12-1
GLOSSARY
OF TERMS
Summary of Contents for 268 SC Sport Cruiser
