21
REMOVAL OF OVEN BURNER AND
PILOT BURNER
CAUTION:
TURN OFF GAS AT MANUAL SHUT OFF
VALVE NEXT TO THE APPLIANCE BEFORE
ATTEMPTING TO LOOSEN ANY GAS
CONNECTIONS.
1. Close manual shut off valve.
2. Remove burner access panel.
3. Remove screws from front of burner
compartment front. Put top of panel forward
and lift out.
4. Disconnect thermocouple of pilot supply
tubing from safety valve.
5. Lift rear portion of burner up so that lugs will
clear burner compartment bottom and slide
burner toward the rear until air miser clears
the orifice fitting.
6. Slide oven burner and pilot assembly out of
burner compartment. To reassemble, reverse
above procedure.
NOTE: Periodically check the condition of the
stainless steel flame baffle (P/N 06139-5). If
baffle has deteriorated or is severely warped, it
should be replaced before the burner flames
damage the oven bottom.
GAS PRESSURE REGULATOR
WARNING:
NO
UNTRAINED
PERSON
SHOULD ATTEMPT TO MAINTAIN OR
SERVICE THE GAS PRESSURE REGULA-
TOR.
REMOVAL OF THE FLAME BAFFLE AND
HEAT BAFFLE ASSEMBLY
1. Remove oven racks and left and right rack
guides.
2. Remove fan baffle.
3. Remove four screws on each side and three
screws on back of oven interior liner bottom.
4. Pry liner bottom up and pull forward to
remove from oven.
5. Lift heat baffle up and remove.
6. Remove flame baffle.
To reassemble, reverse above procedure.
