20
USING THE VIRTUAL WALL
The Virtual Wall allows you to create a virtual barrier, beyond which the vacuum will
not go. Perform the following steps to use the Virtual Wall.
1.
Release the latch on the bottom of the Virtual Wall, then remove the battery
cover.
2.
Insert two D batteries (not included) into the battery compartment. Ensure
that the polarity of the exposed ends of the batteries match the adjacent
polarity markings.
3.
Replace the battery cover and latch it into place.
4.
Place the Virtual Wall on the floor with the hole on the side and the arrow on
the top pointed towards the opposite wall.
5.
Slide the power switch on the Virtual Wall to the on position.
MAINTENANCE
The following cleaning and maintenance procedures should be performed periodically,
as directed in each section.
Cleaning the Dust Bin and Filters
Thoroughly clean the Dust Bin and the filters after each use.
1.
Ensure that the Power Switch on the vacuum is in the off
position.
2.
Press the
area on the top cover to unlatch it, then
open the cover.
