HTP-1 Installation and User Guide Release 1.8.1
Safety Warnings and Guidelines
Please read this entire manual before using this device, paying extra attention to these safety warnings
and guidelines. Please keep this manual in a safe place for future reference.
●
This device is intended for indoor use only.
●
Do not expose this device to water or moisture of any kind. Do not place drinks or other
containers with moisture on or near the device. If moisture does get in or on the device,
immediately unplug it from the power outlet and allow it to fully dry before reapplying power.
●
Do not touch the device, the power cord, or any other connected cables with wet hands.
●
Do not install this device on an unstable surface where it could fall and cause either personal
injury or damage to the device and/or other equipment.
●
Do not subject the product to extreme force, shock, or fluctuations in temperature or humidity.
●
Do not expose this device to excessively high temperatures. Do not place it in, on, or near a heat
source, such as a fireplace, stove, radiator, etc. Do not leave it in direct sunlight.
●
This device ventilates excessive heat through the slots and openings in the case. Do not block or
cover these openings. Ensure that the device is in an open area where it can get sufficient
airflow to keep from overheating.
●
Do not place or install this device in an area where it can be exposed to excessive amounts of
dust, humidity, oil, smoke, or combustible vapors.
●
Use only in a well-ventilated area. Do not use in close, confined spaces. Ensure that there is at
least 3" of space around and above the device.
●
Prior to operation, check the unit and power cord for physical damage. Do not use it if physical
damage has occurred.
●
Before plugging the unit into a power outlet, ensure that the outlet provides the same type and
level of power required by the device.
●
This device uses a grounded power cord and requires a ground connection for safe operation.
Ensure that the power source has a proper ground connection. Do not modify the plug or use a
"cheater" plug to bypass the ground connection.
●
Disconnect the unit from the power source when replacing the fuse. Replace the fuse only with
the same type. Never bypass the fuse.
●
Unplug this device from the power source when not in use.
●
Take care to prevent damage to the power cord. Do not allow it to become crimped, pinched,
walked on, or become tangled with other cords. Ensure that the power cord does not present a
tripping hazard.
●
Never unplug the unit by pulling on the power cord. Always grasp the connector head or adapter
body.
●
Ensure that power is turned off and disconnected before making any electrical connections.
●
Remove the batteries from the controller if it will go unused for a lengthy period of time.
●
Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or detergents. For
stubborn deposits, moisten the cloth with warm water.
●
This device has no user serviceable parts. Do not attempt to open, service, or modify this device.
HTP-1 User Manual
Page 8
V1.8.1
