Mono OMEGA PLUS, Operating And Maintenance Manual

Page: 17 / 67

FG079 –OMEGA TOUCH INCL WIRECUT 03/11 RAC
17
9a FITTING THE HOPPER
CAUTION SHOULD BE TAKEN WHEN FITTING THE HOPPER
AND PUMP ASSEMBLY, AS WEIGHT EXCEEDS 25kgs ON SOME MODELS
It will need to be lifted on by two people, or
dismantled into smaller components before fitting on the machine.
MAKE SURE THE FLOOR AREA AROUND THE MACHINE IS CLEAN
To reduce weight and bulk, fit the complete hopper assembly in two stages - first the
pump assembly onto the support bars, then the feed hopper body onto the pump
assembly.
1 By hand, align pump assembly drive gear roller with drive shaft on machine.
2 Fit hopper to pump assembly and secure with wing nuts.
3 Slide hopper on support bars until fully up against machine.
4
After the hopper is fitted, the safety cover
MUST BE
replaced with the reflector
facing towards the machine body.
PUMP ASSEMBLY
FEED HOPPER
SAFETY COVER
DO NOT OPERATE MACHINE WITHOUT TEMPLATE FITTED
REFLECTOR
Omega
PLUS
FEED HOPPER
WING NUTS
(EACH END)
HARD DOUGH SOFT DOUGH
SUPPORT BARS