Mono OMEGA PLUS, Operating And Maintenance Manual

Page: 14 / 67

FG079 –OMEGA TOUCH INCL WIRECUT 03/11 RAC
14
HARD DOUGH HOPPER
CAUTION:
The feed hopper and pump assembly exceeds 25kg and will need to be lifted off by
two people, or dismantled into smaller components while still on the machine.
To reduce weight and bulk, separate and remove empty feed hopper from pump
assembly, whilst still on the machine, by unscrewing the wing nuts.
(Ensure that the nuts are placed where they will not be lost.)
The pump assembly will now be lighter and more easily removed.
1.
Lift off both upper plastic end-caps.
2. Remove both gears from the assembly, one at a time, by lifting vertically.
3.
Remove remainder of pump assembly from the machine for cleaning.
NOTE :
Use only warm soapy water to clean these parts. They should be rinsed and
thoroughly dried before re-assembly.
The greatest care must be taken not to drop any parts.
Do not leave any components in the hopper.
END CAP
END CAP
Omega
PLUS
WING NUTS
To gain access to the inner wing nut,
slide the complete hopper away from
the machine body slightly (keep on
support bars) - this will also
disengage the pump assembly from
the
drive shaft.