Page 50 of 110
Rev. G
10.
Click Devices Tab in the center menu. Then click the Add Device button. You
will see the following screen. Name the device and click Add Device.
11.
Next you will see a Add Group button appear under the Add Device button.
Click Add Group. You will see the following screen.
12.
Here you will start adding groups which will contain your tags. After naming
the group you will choose between sending this group and all the tags in the
group at a fixed Timed Interval (i.e. every 30 seconds) or On Change.
13.
The Repetition Rate is dependent on the Data Refresh Option chosen. For
Timed Interval this is the time between each data transmission sent for that
group. For example, if 2 minutes go by with Repetition Rate set to 30,000ms or
30 s, you will have sent all tags in that group 4 times in a 2-minute span.
For On Change, the Repetition Rate is how often mCore will look at the data
and check to see if it has changed an equivalent or greater amount than the
Threshold specified per parameter. The Threshold is set in future steps.
14.
Click Store Changes when done.
Summary of Contents for mCore SDR
Page 105: ...Page 105 of 110 Rev G...
