Mondolfo Ferro TBE160 MATIC, Operator'S Manual

Page: 70 / 274

70 - English - Operator's manual
Start the machine with the main switch (A,
Fig. 11) and make sure that the hydraulic
power unit motor is rotating in the direction
indicated by the arrow (Fig. 12) which can
be seen on the motor cap.
Otherwise, the rotation direction must be
corrected immediately in order not to damage
the pump unit.
All machine parts are powered by low voltage
(24V), with the exception of the hydraulic power
unit and the turntable rotation motor inverter,
which are powered with mains voltage.
WARNING
Make sure that all parts of the hydraulic circuit are tightened correctly. If pressurised
oil escapes, it can cause serious injury.
WARNING
The machine is equipped with devices that guarantee the operator's safety:
The tyre changer
uses, on the tool trolley, some protections that prevent crushing between
the tool arm and the sliding trolley and between the tool trolley and the ground.
An acoustic-luminous indicator located on the electrical board is activated by the machine
each time potentially dangerous manual or automatic commands are executed. The
indicator has a flashing orange light.
The following commands activate the acoustic-luminous indicator:
• Turntable opening/closing;
• Turntable lifting/lowering;
• Tool arm + bead breaker disc lifting/lowering.
WARNING
To prevent accidents when using the included or optional accessories, make sure that
the mechanical parts have been correctly installed and well fixed to the parts.
When working, firmly grip the manual accessories.
NOTE
The machine may also be used for tyre grooving.
To enable tyre grooving, set the speed selector (6, Fig. 14a - 6, Fig. 14b) to the first speed
then activate turntable rotation with the relative control. At this point, the turntable
will rotate at a low speed and only in a clockwise direction. Turntable rotation can also
be activated for this operation with a pedal control, using an accessory kit.
12