Monark Cardio Care 827 E, Manual

Page: 6 / 32

Monark Cardio Care 827 E 6
Operating Instruction
Operating Instruction
Workload device
The 827 E uses a brake belt system to control
the resistance. The brake power can be changed
by increasing or decreasing the tension of the
brake belt against the flywheel using the tension
knob(2). See fig: Workload device.
Cycle adjustments
Seat height should be adjusted to a comfortable
position. A suitable height is when your knee is
slightly bent and the middle of the fot is straight
above the pedal axle when the pedal is in its lo-
west position. To adjust the seat height loosen the
lever on the seat tube. See fig: Adjustments.
The handlebar setting shall give a comfortable
position when cycling. During longer exercise
sessions it can be recommended to change hand-
lebar position. To adjust the handlebar loosen the
quick release lever. See fig: Adjustments.
NOTE! The handlebar stem should be inserted
into the frame tube at least 3 inches (about 8 cm).
This measure is marked out on the stem(3).
Fig: Workload device
1) Electronic meter
2) Tension knob
3) Indicator window
Fig: Adjustments
1) Lever, seat post
2) Lever, handlebar
3) Inserted min. 3”
1
min. 3”
3
1
2
3
2