15
The lamp can be replaced by using just a pocket screwdriver.
It is not
necessary to remove any screws to replace the lamp.
To change the lamp:
Push apart the two tabs on the side of the reflector housing and
remove the lens using a small screwdriver to help pry one tab and
lift the lens. Take care not to pry the tab any more than is necessary
to free the lens. The reflector is held in place by the front lens and
will come loose, but it is not necessary to remove the reflector.
Hold the lamp with a cloth between your forefinger and thumb
and rock it back and forth gently while pulling out. Do not attempt
to rotate the lamp. The lamp is socketed and will come out easily
when pulled straight out.
WARNING
Do NOT touch the new lamp with bare fingers.
The lamps are polarized and must be put into the socket matching
polarity.
Using a lint free cloth, match up the red dot on the plug
with the red dot on the socket
and gently rock the lamp while
pushing it into place (see Figure 4). Make sure the lamp is in straight
and centered in the reflector hole.
CAUTION
Do NOT allow the reflector to contact the lamp.
1.
2.
3.
