6
4.0 OPERATION
To turn on the stroboscope, depress and hold the trigger. The trigger may
be locked in position using the side locking button. To lock the stroboscope
on, depress the trigger as far as it will go and then press the locking button.
Once the locking button is set you may release the trigger and the trigger
will be held in place. To unlock the stroboscope, simply depress the trigger
and then release.
N
OTE: Unit must power down completely (
OFF
will be displayed and then
disappear) before unit will power on again. This is normal operation.
There are five (5) operating modes for the Phaser-Strobe pbx. These are
Internal, External Input, External Phase Delay, External Time Delay, and
Auto (Virtual RPM). All but the Internal Mode require an
external input
signal
.
In the
Internal Mode
, the knob adjusts the flash rate. In the
External Input
Mode
, an external signal is used to trigger the flash and the knob has no
effect. The
External Delay Modes (Phase, Time and Auto)
enable the user
to vary the stopped motion image at any point in the cycle without having
to move the trigger source location.
4.1 Internal Mode - Standard Strobe Operation
In the Internal Mode, the stroboscope generates its own signals and
functions like a tunable stroboscope. The strobe is in the Internal Mode
when nothing is plugged into the input jack or when manually set using
the INPUT button.
