9
To adjust the Phase Delay:
1.
Press the
PHASE DELAY
button.
PHASE
will be displayed on the
bottom line and the current flash rate will be displayed on the top
line.
2.
Turn the tuning knob to adjust the location (phase) of the reference
mark.
3.
Press the
PHASE DELAY
button again to turn the Phase Delay mode
off.
4.2 Internal Mode - TACH Frequency Generator
In the Internal Mode, the strobe can be used as a frequency generator
(outputting TTL pulses) without having the strobe flash. The pulse
output will still occur at the flash rate; the strobe is just not flashing.
To stop flashing:
Press the
ALT FUNCTION
button and then the
TACH
button. The TACH
icon will be displayed.
To start flashing again:
Press the
ALT FUNCTION
button and then the
TACH
button. The TACH
icon will go away and the strobe will start flashing again.
4.3 External Input Mode
In the External Input Mode, the user cannot make any flash rate
adjustments. The flash rate is a function of the input signal. This mode
is used to synchronize the flash to an external event (for example, from
an optical sensor) to stop or freeze motion. The flash will be triggered
on the rising or falling edge (menu selectable) of the external input
pulse.
The strobe is in the External Input Mode whenever there is a plug in
the input jack. When the strobe is in the External Input Mode,
EXT
will
be displayed.
