Molift Rail System, Project Planning And Installation

Page: 32 / 112

Schedule of curves
As standard the Molift Rail System has curves with four angles, 30, 45, 60 and 90 degrees. Curves
are only available for the H62 profiles. The curves are as standard supplied with a 500 mm arm ex-
tending from the curve itself. All curves have a radius of 550 mm.
As to the length of the arms and the angle of the curves, these can be specially adapted from the
factory. The price and time of delivery will then be different from the standard. A standard curve
must always be secured using three securing points: one securing point at each end / joint and
a securing point in the middle of the radius. Special Curves must be specified when ordered, see
Figure 23 on page 31. For mounting of curves with special measures, see separate installation guide
from Molift Group AS
Standard curves
Figure 20. Curves H62 CC
Part no. Description Part no. Description
1109100 Rail H62 Curve 30° CC/A 1109105 Rail H62 Curve 30° CC/P
1109101 Rail H62 Curve 45° CC/A 1109106 Rail H62 Curve 45° CC/P
1109102 Rail H62 Curve 60° CC/A 1109107 Rail H62 Curve 60° CC/P
1109103 Rail H62 Curve 90° CC/A 1109108 Rail H62 Curve 90° CC/P
Figure 21. Curve H62 OC
Part no. Description Part no. Description
1109130 Rail H62 Curve 30° OC/A 1109135 Rail H62 Curve 30° OC/P
1109131 Rail H62 Curve 45° OC/A 1109136 Rail H62 Curve 45° OC/P
1109132 Rail H62 Curve 60° OC/A 1109137 Rail H62 Curve 60° OC/P
1109133 Rail H62 Curve 90° OC/A 1109138 Rail H62 Curve 90° OC/P
Page 30 of 106 Chapter 3 - Choice of parts and ordering Rev E 10/2011
Schedule of curves