Commissioning
ESP
NDL
ENG
ITA
FRA
DEU
ENG
40
If the room control unit shall be taught-in to the Alpha IP Base station, the two
devices to be linked must be set to teach-in mode.
1. Select the desired channel at the Alpha IP base station (see Alpha IP Base station
instructions).
2. Press the System key (A) of the Alpha IP base station for 4 seconds, until the LED
of the System key flashes rapidly in orange.
9
The device LED starts to flash in orange.
3. Take off the room control unit Display from the installation bottom (see fig. 3 page 5).
4. Pull out the insulating strip from the battery compartment, or insert batteries (see
fig. 4 page 5). If batteries have already been inserted, press the system key
(D) for at least 4 seconds in order to activate the teach-in mode.
9
The teach-in mode is activated automatically for 3 minutes.
9
The device LED flashes in orange.
The LED will light up in green after a successful teach-in process. If the
LED lights up red, repeat the process.
5.1.2 Teaching-in to Alpha IP Access Point
For a control via the Alpha IP app, the teaching-in must of the RTD 61001-xx must
be performed via the Access Point (HAP 21001). Teach-in the device as follows:
Ö
The Alpha IP Access Point has been set up via the Alpha IP App (see instructions
