Appendix 1 - Updating Controller Software
27
Unplug the electrical connection to
the oven from the wall socket.
Plug the supplied USB into the side
of the control panel.
Plug the electrical connection to the oven into the wall socket.
Display Screen will cycle through a
number of screens as the software
load progresses.
Software load will take approximately
30mins to complete.
NOTE: If software update does
not occur, repeat Steps 1-4.
Only remove USB stick when
prompted ON THE DISPLAY.
Remove USB Stick, the Kitchen Brains screen
will appear as the controller re-initialises.
After a short period of time, the screen will
revert to the ‘Start-Up’ Screen on completion.
CAUTION!
DO NOT REMOVE THE USB STICK DURING THE
SOFTWARE UPDATING PROCESS, AS THIS WILL
CORRUPT THE SOFTWARE UPLOAD.
To controller software can be updated by Power Off/On
Method. Refer below Steps 1-5 for this procedure.
This method is required when the existing controller
software does not already have the Service mode
‘UPDATE SOFTWARE’ feature. See adjacent ‘Update by
Service Menu Method’ Steps 1-2 to check if the Service
Mode option is available.
The controller software can be installed by USB through
the Service Mode if the existing software shows the
option ‘UPDATE SOFTWARE’ in Service Screen 1.
If the existing software does not have this Service Menu
option, the software can be updated by the Power Off/On
Method.
Turn ‘On’ the Cabinet and select the ‘SERVICE’ key.
Enter passcode 4600 on the keypad.
Press key in Service Screen 1.
The warning screen will then display to advise that Updating Soft-
ware will reboot the system (controller).
Press the tick key to proceed with software update.
Press the ‘X’ key if software is not going to be updated.
When the screen shows Plug in USB drive, insert the supplied USB
into the side of the control panel.
Press the ‘X’ key before inserting USB drive only if you
do not wish to proceed with the Software update.
After inserting the supplied new software USB the controller
will automatically start software updating process.
The software update process from this step is the same as
the Power Off/On method.
See adjacent Power Off/On method Steps 4, and 5, describing
the completion of the Software updating process.
