3 Safety instructions
3.4 Device-specific hazards
XP-503 01/2017 MN048014 EN www.eaton.com
17
CAUTION
Electrostatic discharge
Electrostatic discharges may damage or ruin assembly parts.
Do not touch components (e.g., pins) that are electrostatic-sensitive.
Discharge any static electricity from your body before touching the device
(e.g., by touching an earthed metal object).
CAUTION
Non-galvanically-isolated interfaces
The device may be damaged by potential differences.
The GND connections of all bus stations must be connected.
CAUTION
Data loss
If an SSD, HD, or CFast card is being written to and a voltage drop occurs or the
drive/card is removed, data may be lost or the SSD, HD, or CFast card may be
ruined.
Insert SSDs, HDs, and CFast cards only when the device is
de-energized.
Avoid writing to SSDs, HDs, and CFast cards as much as possible. Reasons:
- The number of write cycles for SSDs, HDs, and CFast cards is limited.
- If there is a voltage drop while a write operation is in progress, data loss
is highly likely to occur.
Remove SSDs, HDs, and CFast cards only when the device is
de-energized.
Before switching off the device, make sure that there are no programs writing to
an SSD, HD, or CFast card.
CAUTION
Stable mounting cut required
An IP65 degree of protection will only be ensured if the control panel is stiff enough,
the device is properly mounted using its holding brackets, and the gasket has a
proper seat.
Minimum sheet thickness of control panel panel where the device will be flush
mounted: 1.5 mm.
In order for the device to be properly mounted, every single one of the holding
brackets included with the delivery must be used at its intended spot.