5
Never connect components under load.
Do not mount or support these
fi
xtures in a manner that can cut the outer jacket or damage wire
insula
ti
on.
Unless individual product speci
fi
ca
ti
ons deem otherwise: Never connect an LED product directly to a
dimmer packs, occupancy sensors,
ti
ming devices, or other related control devices. LED
fi
xtures must be
powered directly o
ff
a switched circuit.
Unless individual product speci
fi
ca
ti
ons deem otherwise: Do not restrict
fi
xture ven
til
a
ti
on. Allow for
some volume of airspace around
fi
xture. Avoid covering LED
fi
xtures with insula
ti
on, foam, or other
material that will prevent convec
ti
on or conduc
ti
on cooling.
Unless individual product speci
fi
ca
ti
ons deem otherwise: Do not exceed
fi
xtures maximum ambient
temperature.
Only use
fi
xture in its intended loca
ti
on.
LED products are Polarity Sensi
ti
ve. Ensure proper Polarity before installa
ti
on.
Electrosta
ti
c Discharge (ESD): ESD can damage LED
fi
xtures. Personal grounding equipment must be
worn during all installa
ti
on or servicing of the unit.
Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter
performance.
Some components inside the
fi
xture may not be serviceable. In the unlikely event your unit may require
service, stop using the unit immediately and contact an ABL representa
ti
ve for assistance.
Always read the
fi
xtures complete installa
ti
on instruc
ti
ons prior to installa
ti
on for any addi
ti
onal
fi
xture
spec
ifi
c warnings.
CAUTION: RISK OF PRODUCT DAMAGE
Disconnect or turn o
ff
power before
installa
ti
on or servicing.
Verify that supply voltage is correct by
comparing it with the luminaire label
informa
ti
on.
Make all electrical and grounded
connec
ti
ons in accordance with the Na
ti
onal
Electrical Code (NEC) and any applicable
local code requirements.
All wiring connec
ti
ons should be capped
with UL approved recognized wire
connectors.
WARNING
RISK OF ELECTRIC SHOCK
Allow lamp/
fi
xture to cool before handling.
Do not touch enclosure or light source.
Do not exceed maximum wa
tt
age marked on
luminaire label.
Follow all manufacturer’s warnings,
recommenda
ti
ons and restric
ti
ons for: driver
type, burning posi
ti
on, moun
ti
ng
loca
ti
ons/methods, replacement and
recycling.
WARNING
RISK OF BURN
Wear gloves and safety glasses at all
ti
mes
when removing luminaire from carton,
installing, servicing or performing
maintenance.
Avoid direct eye exposure to the light source
while it is on.
CAUTION
RISK OF INJURY
Keep combus
ti
ble and other materials that
can burn, away from lamp/lens.
Do not operate in close proximity to persons,
combus
ti
ble materials or substances
aff
ected by heat or drying.
CAUTION
RISK OF FIRE
Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory statements.
Failure to follow any of these instructions could void product warranties.
