77
For a better explanation, figure 51 is shown once again on the right.
PT = Initiation point
Position in the braking curve when ABS control initiates (0%...100%)
WD = brake reset value
Value for how much the brake is to be released (0%... 100%) at 0% the brake is not release (no ABS
function!) at 100% the brake is fully released.
CY = braking cycles
Number of braking impulses per time unit (0...30)
DL = Initiation delay
Time until the ABS is activated from the start of a braking event (1...100); the smaller the value the
faster the ABS function initiates.
SM = Mixer
Mix function for Channel 3 (AUX), only active if either "AUX" or "TH&AUX" has been selected under
"MODE"; you can adjust how the ABS is mixed on the AUX channel (Channel 3) (0%...100%)
DT = Braking impulse rate
Changes the pulse width from "brake activated" to "brake released"
MODE = Assignment of the ABS function to Channel 2 and 3
"INH" = ABS deactivated, "TH" = ABS function for Channel 2, "AUX" = ABS function for Channel 3,
"TH&AUX" = ABS function for Channels 2 and 3
ABS 11.2V
PT
:10% WD:50
CY:15% DL:0
SM:0% DT:1
MODE:INH
Figure 52 (= Figure 51)
Summary of Contents for 20 72 54
Page 200: ...198 ...
Page 201: ...199 ...
