Mocon Dansensor Lippke 4000, User Manual

Page: 54 / 77

Dansensor A/S COPYRIGHT © P/N 330654-E 01/2018
Lippke 4000/4500 EN User Guide 53
Connecting hoses and cables
NOTE! The Lippke 4000/4500 device and the various accessories must be placed on an
even and steady surface with sufficient working area for the type of packages to be tested.
1. You have 3 connection possibilities for the “Clamp” connector:
- If you are using the device together with a PPC 300 II unit and you want the device to control the
lower clamp bar of the PPC 300 II, connect a hose

from the “Clamp” outlet to the “Control
Lower Bar” inlet on the PPC 300 II.
- If you are using the device as a part of the MultiCheck system, connect a hose

from the
“Clamp” outlet to the MultiCheck test head.
- If the “Clamp” outlet is not to be used, it must be plugged using the special rubber plug

that
comes with the device.
2. Connect the compressed air supply

to the “Air Supply” inlet connector - see "Compressed air
supply requirements" on page 51 for details.
3. Connect the hose from the “Feed” outlet connector

to the appropriate accessory air supply
connector.
4. Connect the hose from the “Sense” inlet connector

to the appropriate accessory pressure
measurement outlet connector.
5. The “Accessory Port” connector has 2 functions:
- If you are using the device as a part of the MultiCheck system, connect the 15-pin Sub-D
communication cable

from the PacCheck 3XX to the “Accessory Port” connector.
- If you want to start and stop the device from an external source (ex. a foot switch) connect the
15-pin Sub-D cable

between the “Accessory Port” connector and the control device.
See "Connection of external control device" on page 54 for details.
1 2 3 4 5
6 7
8