Mocon AMETEK Dansensor Lippke 5000, User Manual

Page: 68 / 136

66 User Guide EN Dansensor
®
Lippke
®
5000
P/N 380419-C
05/2022
Creep test
Creep2Fail test
Bubble test
The result of a bubble test is basically determined by seeing if bubbles come out of the
package or not. If you want to save the test results in the
Test Log , this can be achieved by
enabling the parameter Enter Test Result (Bubble Test) in Settings -> Device .

Two buttons will now appear on the test screen with which you can select whether the test is
approved or not. Thus, if you press the
button, the test result will subsequently be
indicated and registered as PASS , whereas pressing the button will indicate and register
the result as FAIL .
PASS
No Burst
FAIL
23 sec
Package does not
burst at the specified
pressure within the
specified pressure
test time
Package bursts at or
below the specified
pressure.
Package bursts after
23 sec.
PASS
23 sec
FAIL
18 sec
FAIL
36 sec
FAIL
No Burst
Package bursts at the
specified pressure
within the specified
time range.
Package bursts at the
specified pressure
below the specified
time range
Package bursts at the
specified pressure
above the specified
time range
Package does not
burst