Mobius Bionics LUKE Arm, User Manual

Page: 80 / 177

18
Use or Disclosure of Data Contained on this Page is Subject to the Copyright Restrictions on the Inside Title Page of this Document --Rev. 1.5
About This Guide
How to Use This Guide
The following table summarizes the information in this guide.
Read To Learn About...
Section I — Arm System Overview
Chapter 1, “Overview”
Overview
— Provides introductory information about the client
needs as they relate to the LUKE arm and system components
used to fit, set up, and configure the arm.
Chapter 2, “Safety”
Safety
— Provides all safety
WARNINGS
,
CAUTIONS
, and
notices you and your client must read prior to setting up and
configuring the arm and system components.
Chapter 3, “User Inputs/Outputs
and the Control Scheme”
Determining the Control Scheme
— Provides information on
the types of user inputs which you will use to determine the arm’s
control scheme.
Chapter 4, “Battery Types and User
Controls”
Arm Configurations
— Provides information on the battery
types used in specific arm configurations as well as information on
the display and buttons used to control the arm.
Section II — Mounting and Setting Up the Arm System
Chapter 5, “Arm System Installation
and Setup” Setting Up the LUKE Arm — Provides high-level steps you
need to perform to install and set up the LUKE arm. These
high-level steps are cross-referenced to specific chapters where
detailed information is provided.
Chapter 6, “Fabricating the Socket
System and Mounting the Arm” Fabricating the Socket and Harness — Provides information
about fabricating and building the socket as well as how to attach
the arm types to the socket.
Chapter 7, “Installing/Connecting
ACI Modules and User Inputs” Installing and Connecting ACI Modules — Provides
information on installing and connecting ACI Modules.
Chapter 8, “Installing IMUs” Installing and Connecting the User Inputs — Provides
information on connecting the user inputs to the ACI Modules.
Chapter 9, “Installing, Connecting,
and Charging the System Batteries” Selecting the Battery — Provides information on selecting the
battery that will be used to power the arm.
Section III — Configuring the Arm
Chapter 10, “Key Concepts and
Operating Modes” Understanding Arm Concepts — Provides conceptual and
operational information about the arm.
Chapter 11, “Configuring the Arm
Using the Prosthetist Interface” Configuring the Arm Using Prosthetist Interface —
Provides information on using the Prosthetist User Interface
software to configure the arm.