Initial Setup
Series 358 Micro-Ion Controller Instruction Manual - 358013 - Rev. B
29
Sy
stem C
o
mponents
Ini
tial
Setup
Installation
Before You
Begin
Figure 3-3
Ion Gauge Electrometer Module TopView
5.
Set the switch to the desired position: Off = Torr/mbar units;
On = pascal units.
You must also change the setting of the unit of measure switch on the
Dual Convectron gauge as described in
6.
To change the units of measure label on the front of the Controller,
open the door and lift the label card from its slot in the top of the front
panel. Units of measure labels are included in the mounting hardware
kit.
Figure 3-4
Removing the Units of Measure Label Card
Unit of Measure
Slow Update
Overpressure Shutdown
Potentiometer
Units of measure switch
ON and OFF positions
X
OFF
X
ON
1
2
IG
7.5 – 6
A
B
6.4 – 2
3.2 + 2
1
DEGAS
-
2
-
3
-
O N
O F F
GAUGE
O N
O F F
358 Micro-Ion Controller
4
-
5
-
6
-
TORR
Summary of Contents for Granville-Phillips 358 series
