9
5. Thou hast interface
Click "ok" button, the interface inversion can be 180 degree show.
6. English interface
Click "ok" button, the interface, switch to English mode.
7. Chinese interface
Click "ok" button, the interface, switch to the Chinese model.
8. The factory menu
Enter the factory interface, display, please enter the password: XXXXXX. Specific operation process: press the up
and down key to choose Numbers (a *) at a time. Password input after fully, finally press the "OK" (OK) key
password authentication.
Options
Instructions
Reset the
calibration (fine)
0-255
X calibration
0-255
Y
calibration
0-255
The dimming calibration
0-255
Color wheel alignment
0-255
Pattern plate of the calibration
0-255
Focusing calibration
0-255
Prism calibration
0-255
Fog lens calibration
Channel Settings
Can be set up channel switch
Screen saver mode
Pattern 1
According to address code
Pattern 2
According to factory LOGO
Pattern 3
No display (reserve)
Bright time reset
NO/YES
Maintenance:
To prolong the life of the projector, some maintenance work has to be done to ensure the optical
system in good condition. If the projector does not function, check the fuses on the power socket of
the projector, they should only be replaced by fuses of the same specification. Should these be
damaged, call a qualified technician before replacement. The projector has thermal protection
device that will switch off the projector in case of overheating. Should either of these operate, check
that the fans are not blocked, and if they are dirty, clean them before switching on the projector
again. Check that the fans are operational, if not, call a qualified technician.
☆
Any maintenance work should only be carried out by qualified technicians.
