![background image](http://html.mh-extra.com/html/mitsubishi/mj-e26vx-a1/mj-e26vx-a1_service-manual_1809047006.webp)
6
¡
AUTO
The unit maintains the humidity level by
automatically controlling airflow and operating
intermittently as necessary. All you have to do is set
the humidity level.
¡
The unit turns off when current humidity drops
blow the set humidity level (airflow and louvre
stop). The unit restarts when humidity rises
above the set level.
¡
The unit operates for 6 minutes continuously
regardless of the humidity level immediately after
turning the power on.
Frequent use of exits and room size/conditions
may cause the humidity to not reach the set
level.
<To view set humidity level/ To set humidity level>
¡
Pressing the button once displays
the set humidify level with the
indicator. After 3
seconds, the display
returns to the current
humidity display.
¡
Pressing HUMIDITY
SELECTION while
is
displayed sets the humidity level.
Each time the button is pressed, the
humidity setting changes.
¡
AIR PURIFIER
The unit cleans the air by passing it through the pre-filter and photocatalytic filter. The dehumidifying function is disabled.
∞
The air passes through the pre-filter and photocatalytic filter in all modes, cleaning the air even if the
air purifier lamp is not lit.
∞
Cigarette smoke and toxins found in smoke, such as carbon monoxide, cannot be removed with these filters.
Information
Information
Press
Press
again
65
70
50
55
60
¡
Swing louvre function (how to read the swing monitor)
The louvre can be made to swing. Select from the 5 possible settings to suit the purpose.
Press
¡
Starts swing operation.
¡
The swing monitor is
displayed.
This indicates the range of louvre swing.
(The louvre and monitor do not move in synchronization.)
∞
The level of noise emitted from the unit varies according to the angle of the air-flow.
∞
The louvre may stop up to a maximum of 8 seconds to correct its position, after which it will start moving again.
∞
If the louvre is knocked out of the desired angle, readjust by following the above steps.
The swing operation stops when the power cord
is unplugged.
30
°
Objective
Recommended swing setting
Explanations of the swing modes
Convenient for
drying carpets or
beds.
To stop the
louvre at the
desired angle
To cover the
entire room
For drying
clothes, etc.
For directing air
into a closet
¡
Stop swing operation
¡
WIDE
¡
UPWARD
¡
LOW AIR OUTLET
¡
REAR
Swing speed is automatically controlled to send
air at washing from the all angles.
The louvre swings from the UPWARD position
through to the REAR position in order to send
air to all corners of the room.
The louvre stops in a vertical position. The swing
monitor turns off.
To change the louvre to a desired angle, wait
until the louvre stops, then adjust by hand.
The louvre moves slowly through the
last 30° of the swing, as the time
taken to traverse the rear arc is
shorter than that for the upward arc
when moving at a constant speed.
The swing function is not available.
Adjust the angle manually (from
three possible positions).
When using the low air outlet, do not close
the louvre, as it needs to open slightly to
make directional adjustments.
Move the louvre
from the sides.
Depending on the angle of the louvre, some air
may blow out of the low air outlet.
Information
Summary of Contents for MJ-E26VX-A1
Page 24: ...24 7 4 General Block Diagram ...
Page 25: ...25 ...