![background image](http://html.mh-extra.com/html/mitsubishi/mj-e26vx-a1/mj-e26vx-a1_service-manual_1809047032.webp)
32
4. Removing the blower fan assembly
Repairable
parts
Float switch, blower motor,
and blower fan
Picture 10
Setscrew
Blower fan
assembly
Setscrew
Board holder
assembly
Setscrew
Setscrew
Connector
cover
Picture 7
Float
switch
Picture 11
Setscrew
Picture 13
Leadwires
Picture 9
Picture 12
Duct
Hook
Blower fan setscrew
Setscrews
Duct
Be sure to attach
the mica sheet
when mounting
the board to the
holder.
<<Demounting the power supply board>>
Step 1) Detach the connector cover.
2) Pull out the board connectors.
3) Pull out the board holder assembly setscrews
(2) and remove the holder assembly.
4) Open the cover by unhooking if from the
board holder.
(See Picture 7.)
5) Remove the compressor capacitor and the
connector (P4), demount the board and
remove mica sheet.
(See Picture 8.)
Picture 8
Step 1) Detach the front panel assembly and rear
panel as directed in Procedures 1 to 3
above.
2) Disconnect leadwires from the motor support
case.
(See Picture 9.)
3) Remove blower fan assembly setscrews (2).
(See Picture 10.)
4) Lift off the blower fan assembly.
<<Removing the float switch>>
Step 1) Remove the float switch.
Note: Handle the float switch with care when removing
and reinstalling it.
(See Picture 11.)
<<Removing the blower motor>>
Step 1) Remove setscrews (2) and then release duct
hooks (3).
(See Picture 12.)
2) Remove the blower fan and set nut (1) to
release the fan.
(See Picture 12.)
3) Remove the duct, the motor support frame
and setscrews (4) to release the support
frame.
(See Picture 13.)
Summary of Contents for MJ-E26VX-A1
Page 24: ...24 7 4 General Block Diagram ...
Page 25: ...25 ...