Mitsubishi HS-7496E, Installation And Operation Manual

Page: 9 / 32

8
DISPLAY
Sets the date, time and direction to search for the desired location on a tape.
1 SETTING THE TIME
Turn the JOG dial to set the hour and minute to search for.
2 SETTING THE DATE
Turn the JOG dial to set the day of the month to search for.
3 SETTING THE DIRECTION
Turn the JOG dial to select the starting direction for search.
FORWARD:
Search in the forward direction.
REVERSE: Search in the reverse direction.
• If the desired part of a tape is not found in one direction, the VCR automatically searches in the
opposite direction.
After the setting, turn the SHUTTLE ring to the right to start searching.
1 SETTING THE DISPLAY MODE (DISPLAY MODE)
DISPLAY MODE 1:
Displays date and present time. (Refer to page 11.)
DISPLAY MODE 2: Displays date, day of the week, present time and recording mode.
(Refer to page 11.)
DISPLAY MODE 3: Displays nothing; until an alarm recording starts, then date, alarm
recording number, etc. is displayed.
DISPLAY MODE 4: Displays nothing; even in the case of alarm recording, nothing is
displayed on the monitor.
• During an alarm recording, alarm recording number is displayed if the “DISPLAY MODE” is
set from 1 to 3.
2 SETTING THE SIZE OF THE LETTERS OF DAY AND PRESENT TIME DISPLAY
(TIME DATE SIZE)
SMALL:
The size of the letters becomes small.
LARGE: The size of the letters becomes large.
TIME DATE SEARCH
MAIN MENU
1 DISPLAY
Sets the display format of the date and present time on the monitor.
2 TIME DATE SEARCH
Sets the date, time and direction to search for the desired part of a tape.
3 TIMER PROGRAM
Sets the timer recording.
4 RECORDING SET UP
Sets the alarm recording mode, alarm recording duration and emergency recording.
5 REAR TERMINAL
Sets the frequency division ratio of CLOCK OUT, output signal of the CALL OUT
terminal and the MODE OUT terminal, etc.
6 MAINTENANCE
Displays the power loss list, alarm loss list and initializes all menu settings. Clears
the power loss list and alarm list.
7 FIRST TIME SET UP
Set up for when the end of the tape is reached, quasi v-sync, present time and
communications parameters of the optional RS-232C interface.
<MAIN MENU>
DISPLAY
TIME DATE SEARCH
TIMER PROGRAM
RECORDING SET UP
REAR TERMINAL
MAINTENANCE
FIRST TIME SET UP
Use JOG to select,
and ENTER.
Press DISPLAY to exit.
<DISPLAY>
1
SMALL
11 – 11 – 98 09 : 21 : 01
DISPLAY MODE
TIME DATE SIZE
Ex. <MODE 1>
<TIME DATE SEARCH>
15:00
23
FORWARD
TIME
DATE
DIRECTION
Use JOG to adjust,
and ENTER.
N
• An hour index mark is written on the tape on the hour and is used as a reference in the search function. Because of this, a
recorded tape must pass a time clock hour mark before this function can work. The TIME DATE SEARCH function begins after
the first hour index mark.
Example 1:
VCR is set to record from 8:30 to 17:30 - Times from 9:00 to 17:30 can be found.
Example 2: VCR is set to record in one speed from 7:00 to 14:30, then in another speed until 18:00.
- Times from 7:00 to 14:30 and 15:00 to 18:00 are accurately located.
• Time date search function is not available for a tape recorded by any other VCR than this model.
• If recording quality is poor, the VCR may fail to locate the desired part of the tape during time date search.
TIMER PROGRAM
Refer to page 18 “TIMER RECORDING” for details.