flat surface of ratating disk.
(1) When the magnet is
led on the counter-load
side of spindle, the ref-
erence hole of magnet and
reference notch of sensor
head should face inward,
as shown in Fig. 6.4.
When the magnet is instal-
led on the load side of
spindle,
the reference hole
of magnet and reference
notch of sensor head should
face outward, as shown in
Fig. 6.5.
from
hole
Reference notch
View from
Magnet is installed on the
Magnet is installed on the
counter-load side.
load side.
In
the magnet and sensor head can
be located,
as shown below, so far as the
magnet is aligned with the sensor head cor-
rectly.
When the magnet and sensor head are instal-
led, as shown below, however, bit for para-
meter (orientation of oriented spindle stop
detector) must be changed correspondingly
(parameter 0RS2).
Reference hole
Reference notch
75
