Parameter
Description
(uni
range
For details,
refer to the Specifi-
cation
11
Data 1
These data are valid when
is
Decimal
12 DT02
Data 2
set for #10 parameter
tion
13 DT03
Data 3
14 DT04 Data 4
Speed reference signal selected
15 DT05
Data 5
by speed reference signal select
16 DT06
Data 6
signal is set for each data.
17 DT07 Data 7
Data is set in terms of motor
18 DT08
Data 8
speed within the range up to the
19
Data 9
motor maximum speed set by
Data 10
parameter
Data 11
DT12 Data 12
DT13
Not used.
Set
DT14
Not used.
Set
DT15
Not used.
Set
20
Not used.
Set
21
The larger the setting, the short- 0 360
or
er is the time taken for oriented
ed stop
spindle stop,
and the higher is
position
the servo stiffness.
control
If setting is excessively large,
loop gain
however,
intense vibration may
occur,
resulting in overrun.
Standard setting: See Table 1.
22 PG2
Encoder
Same as above
360
oriented
spindle
stop po-
sition
control
loop gain
Standard setting: See Table 1.
23 PGC
Sync.
TAP Spindle position control loop
512
gain in sync. TAP is set.
Standard setting: See Table 1.
For NC display
(NC display standard
parameter,
999.99
.
24 ZRZ
Oriented
In-position range within which
Encoder
spindle
"oriented spindle stop complete
sensor
stop
(in-position)"
signal is output
position
is set.
5760
512
range
deg.)
deg.
Standard setting: 16
For parameter
(NC display standard setting:
on NC display
1.00)
deg.
