Mitsubishi MOTORS PAJERO OBKE10E1, Owner'S Manual

Page: 355 / 394

2. Remove the bulb from the socket by pulling
out.
3. To install the bulb, perform the removal
steps in reverse.
Front turn-signal lamps
E01003800733
1. Turn the bulb socket anticlockwise to re-
move it.
2. Remove the bulb from the socket by pulling
out.
3. To install the bulb, perform the removal
steps in reverse.
Front fog lamps*
E01004001191
1. Remove the 5 clips (A, C) and screw (B) by
following procedures then turn up the cover
(D).
2. Depress the tab (E) on the harness connector
(F) and pull the harness connector to remove
it.
3. Remove the entire socket and bulb assembly
(G) by turning it anticlockwise.
CAUTION
l Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the fog lamps
are used. If the glass surface is dirty, it
must be cleaned with alcohol, paint thin-
ner, etc., and refit it after drying thorough-
ly.
Maintenance
8-25
8