Mitsubishi MOTORS PAJERO OBKE10E1, Owner'S Manual

Page: 59 / 394

To fasten
1. Pull the seat belt out slowly while holding
the latch plate.
NOTE
l When the seat belts cannot be pulled out in a
locked condition, pull the belts once forceful-
ly and then return them.
After that, pull the belts out slowly once again.
2. Insert the latch plate into the buckle until a
“click” is heard.
WARNING
l Never wear the lap portion of the belt
across your abdomen. During accidents it
can press sharply against abdomen and in-
crease the risk of injury.
l The seat belts must not be twisted when
worn.
3. Pull the belt slightly to adjust slackness as de-
sired.
To unfasten
Hold the latch plate and push the button on the buck-
le.
NOTE
l As the belt retracts automatically, keep the
latch plate held while retracting so that the
belt stows slowly. Failure to do this could
damage the vehicle.
Seat belt reminder/warning lamp
E00409800338
The seat belt warning lamp is located on the instru-
ment panel.
A tone and warning lamp are used to remind the
driver to fasten the seat belt.
When the ignition key is turned to the “ON” posi-
tion, the warning lamp will illuminate and a tone
will sound for about 6 seconds. If the driver’s seat
belt remains unfastened for approximately
1 minute later, the warning lamp will flash and the
tone sound intermittently (each 12 times) when the
vehicle is driven. If the driver subsequently unfas-
tens the seat belt while driving, the warning lamp
and tone will issue further warnings. And if the
seat belt remains unfastened, the warning lamp and
tone will issue further warnings each time the vehi-
cle starts moving from a stop. When the seat belt is
fastened, the warnings will stop.
Adjustable seat belt anchor (front
seats)
E00405000286
The seat belt anchor height can be adjusted.
Seat and seat belts
2-21
2