Mitsubishi MOTORS Lancer Evolution 2009, Owner'S Manual

Page: 282 / 362

NOTE
l
In cold conditions (when the ambient temper-
ature is 0 °C or lower), thickening of the tyre
sealant can make the tyre sealant hard to
squeeze out of the bottle. Warm the bottle in-
side the vehicle.
7. Do not remove the seal (C). Screw the filler
hose (D) onto the bottle (E). As you screw
the filler hose onto the bottle, the seal will
break, allowing the sealant to be used.
CAUTION
l If you shake the bottle after screwing on
the hose, sealant may spray out of the hose.
8. Take the valve cap (F) off the tyre valve (G),
then press the valve remover (H) onto the
valve as illustrated. Allow all of the air in the
tyre to escape.
Type A Type B
9. Remove the valve insert (I) by turning it anti-
clockwise using the valve remover (H). Put
the removed valve insert in a clean place so
it does not get dirty.
Type A Type B
CAUTION
l If there is any air left in the tyre when
you remove the valve insert, the valve in-
sert may fly out and injure you. Make
sure the tyre contains no air before remov-
ing the valve insert.
10. Remove the plug (J) from the free end of the
hose (K). Press the hose onto the valve (G).
11. Holding the sealant bottle upside-down,
squeeze it again and again to inject all of the
sealant into the tyre.
For emergencies
6-08
6