Mitsubishi MOTORS Lancer Evolution 2009, Owner'S Manual

Page: 56 / 362

NOTE
l When lending the vehicle to another person
or allowing the vehicle to be driven by some-
one who is unfamiliar with the security
alarm system, be sure to give the person a
proper explanation of the security alarm sys-
tem.
If a person who is unfamiliar with the securi-
ty alarm system accidentally unlocked the ve-
hicle, causing the alarm to sound, the alarm
would be a nuisance to people nearby.
Changing the system settings
E00301600195
When making changes to the settings, be sure to fol-
low the procedure below.
1. Turn the ignition switch to the “LOCK” posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Place the lamp switch in the “OFF” position,
and leave the driver’s door open.
3. Pull the windscreen wiper and washer switch
towards you and hold it there.
(Since the ignition switch is in the “LOCK”
position, washer fluid will not be sprayed.)
4. After approximately 10 seconds, the buzzer
will make a sound. Keep the windscreen wip-
er and washer switch pulled towards you.
(If the windscreen wiper and washer switch
was released, the setting change mode would
be cancelled. To start over, perform the pro-
cedure again from step 3.)
5. When the buzzer stops, with the windscreen
wiper and washer switch still pulled towards
you, press the UNLOCK switch (A) on the re-
mote control switch to select the security
alarm settings mode.
Except for vehicles with the keyless operation system
Vehicles with keyless operation system
The settings mode can be toggled by press-
ing the UNLOCK switch. The mode can be
confirmed from the number of times the buz-
zer sounds.
Locking and unlocking
1-32
1