Mitsubishi MOTORS CARISMA 1996, Service Bulletin

Page: 181 / 232

3
BRAKE DISC THICKNESS CHECK
1. Using a micrometer, measure disc thickness at eight positions,
approximately 45° apart and 10 mm in from the outer edge of
the disc.
Brake disc thickness
Standard value:
<1600> 18.0 mm
<1800> 24.0 mm
Limit:
<1600> 16.4 mm
<1800> 22.5 mm
Thickness variation (at least 8 positions)
The difference between any thickness measurements should
not be more than 0.015 mm.
2. If the disc is beyond the limits for thickness, remove it and install
a new one. If thickness variation exceeds the specifications,
replace the brake disc or turn rotor with on the car type brake
lathe (“MAD, DL-8700PF” or equivalent).
BRAKE DISC RUN-OUT CHECK
1. Remove the caliper support: then raise the caliper assembly
upward and secure by using wire.
2. Inspect the disc surface for grooves, cracks and rust. Clean the
disc thoroughly and remove all rust.
3. Place a dial gauge approximately 5 mm from the outer
circumference of the brake disc, and measure the run-out of the
disc.
Limit: 0.07 mm or less
NOTE
Tighten the nuts in order to secure the disc to the hub.
35A-12
BASIC BRAKE SYSTEMS – On-vehicle Service
35100160047
B14S0019
14F612
35100170040
14F611
<New>
21.5 mm
<From February 12, 1996>
<Old>
<Up to february 11, 1996>
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk