Mitsubishi MOTORS CARISMA 1996, Service Bulletin

Page: 165 / 232

14
(2) Install the spider assembly to the shaft from the direction
of the spline bevelled section.
(3) After applying the specified grease to the T.J. case,
insert the drive shaft and apply grease one more time.
Specified grease: Repair kit grease
Amount to use: 120 g
NOTE
The grease in the repair kit should be divided in half for use,
respectively, at the joint and inside the boot.
Caution
The drive shaft joint uses special grease. Do not mix old
and new or different types of grease.
! ! ! !
C
" " " "
T.J. BOOT BAND (SMALL)/T.J. BOOT BAND
(LARGE) INSTALLATION
Set the T.J. boot bands at the specified distance in order to
adjust the amount of air inside the T.J. boot, and then
tighten the T.J. boot bands sercurely.
Standard value (A): 82 mm
INSPECTION
•
Check the drive shaft for damage, bending or corrosion.
•
Check the drive shaft spline part for wear or damage.
•
Check the spider assembly for roller rotation, wear or
corrosion.
•
Check the groove inside T.J. case for wear or corrosion.
•
Check the dynamic damper for damage or cracking.
•
Check the boots for deterioration, damage or cracking.
B.J. BOOT (RESIN BOOT) REPLACEMENT
(1) Remove the B.J. boot bands (large and small).
NOTE
The B.J. boot bands cannot be re-used.
(2) Remove the B.J. boot.
(3) Wrap a plastic tape around the shaft spline, and
assemble the B.J. boot band and B.J. boot.
<Added>
A1120004
A11P0124
11X0132
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk