OPERATING PROCEDURE
PHOTOS/FIGURES
7. Removing the louver motor
(1) Remove the intake grille. (Refer to Procedure 1)
(2) Remove the electrical parts cover. (Refer to Procedure 2)
(3) Remove the front panel. (Refer to Procedure 6)
(4) Remove the 5 screws of the swing louver and remove the
swing louver.
(5) Remove the 2 screws of the louver motor and remove the
louver motor.
(6) Disconnect the blue connector CNP (LOUVER) on the
indoor controller board.
Photo 7-1
Photo 7-2
8. Removing the indoor coil thermistor
(1) Remove the intake grille. (Refer to Procedure 1)
(2) Remove the electrical parts cover. (Refer to Procedure 2)
(3) Remove the front panel. (Refer to Procedure 6)
(4) Remove the swing louver. (See Photo 7-1)
(5) Remove the 10 screws of the insulation panel and remove
the insulation panel .
(6) Remove the screw of the piping cover and remove the pip
-
ing cover.
(7) Remove the indoor coil thermistor from the holder on the
copper pipe.
(8) Disconnect the connector CN44 on the indoor controller
board.
Photo 8-1
Photo 8-2
32
33
OCH724
Top panel
Screws of
swing louver
Screws of
top panel
Swing
louver
Screws of
swing louver
Swing louver
<Back view of swing louver>
Screws of
louver motor
Louver
motor
Piping cover
Screw
Screws of
insulation
panel
Insulation panel
Indoor heat
exchanger
Thermistor
<Pipe temp.>
(TH2)
Thermistor
<Cond./Eva.temp.>
(TH5)
Screws of
insulation
panel
