106
MCFH MICROPROCESSOR CONTROL
8
WIRELESS REMOTE CONTROLLER
Once the operation mode is set, the same operation mode
can be repeated by simply turning OPERATE/STOP
(ON/OFF) button ON.
Indoor unit receives the signal with a beep tone.
When the system turns off, 3-minute time delay will operate
to protect system from overload and compressor will not
restart for 3 minutes.
8-1. “I FEEL CONTROL” (
) OPERATION
(1) Press OPERATE/STOP(ON/OFF) button on the
remote controller. OPERATION INDICATOR lamp of
the indoor unit turns on with a beep tone.
(2) Select “I FEEL CONTROL”
(
)
mode with
OPERATION SELECT button.
(3) The operation mode is determined by the room tem-
perature at start-up of the operation.
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
I FEEL COOL
HEAT DRY
PM
CLOCK
AM
RESET CLOCK
ON/OFF
TOO
COOL
PM
AM
TOO
WARM
Signal transmitting section
Operation display section
OPERATE /STOP
(ON /OFF)button
TEMPERATURE buttons
OPERATION SELECT button
FAN SPEED CONTROL button
OFF-TIMER button
ON-TIMER button
RESET button
ECONO COOL button
VANE CONTROL button
CLOCK SET button
HR. button
MIN. button
(TIME SET button)
Indication of remote controller
model is on back
Operation time chart
Example
Previous operation
COOL mode of
“I FEEL CONTROL”
or COOL mode
• Once the mode is fixed, the mode does not change by
room temperature afterwards.
• Under ON-TIMER (
) operation, mode is deter-
mined as follows.
When the system is stopped with OPERATE/
STOP(ON/OFF) button on the remote controller, and
restarted within 2 hours in “I FEEL CONTROL”
(
)
mode, the system operates in previous mode automat-
ically regardless of the room temperature.
Operation time chart
Example
Previous operation
COOL mode of
“I FEEL CONTROL”
or COOL mode
When the system is restarted after 2 hours and more,
the operation mode is determined by the room temper-
ature at start-up of the operation.
Restart
COOL mode of
“I FEEL CONTROL”
Restart
COOL or DRY or
HEAT mode of “I
FEEL CONTROL” that
is determined by room
temperature at start-up
of the operation.
Lighted
Not lighted
Approx.
2
:
or more
Difference
between target
temperature
and room
temperature
Approx.
2
:
or less
This shows that the
air conditioner is
operating to reach
the target temperature.
Please wait until the
target temperature is
obtained.
This shows that the
room temperature is
approaching the
target temperature.
Operation state
Indication
Operation Indicator
Operation Indicator lamp
The operation indicator at the right side of the indoor
unit indicates the operation state.
INDOOR UNIT DISPLAY SECTION
• The following indication applies regardless of shape of
the indicator.
MCFH-GA35VB MUCFH-GA35VB
MCFH-GA50VB MUCFH-GA50VB
MCFH-GA60VB MUCFH-GA60VB
Mode
COOL mode of
"I FEEL CONTROL"
DRY mode of
"I FEEL CONTROL"
HEAT mode of
"I FEEL CONTROL"
Initial room temperature
25
:
or more
23
:
to 25
:
less than 23
:
OBT06D--4qxp 07.3.2 9:53 AM Page 106
