69
OPERATING PROCEDURE
PHOTOS
Photo 6
4. Removing the compressor
(1)Disconnect the cord connector. (See Phot 5)
(2)Remove the set screws of the relay panel.
(3)Remove the set nuts of the terminal cover.
(4)Pull up the compressor.
(5)Pull out the lead wires from the compressor terminal
to remove overcurrent relay.
(6)Remove set nuts of the compressor base.
(7)Remove the low pressure side welded part and high
pressure side welded part using a burner.
NOTE
●
Before using the torch, reclaim gas from the pipes until the
pressure gauge shows 0 PSI(GAUGE).
●
Use the torch under the condition that gas can be released
even when the inner pressure rises by heat.
●
Reclaim all refrigerant in an environmentally acceptable
manner.
Set nuts of the terminal cover
Nuts
