- 13 -
3. Setting
3.1 Setting flow
To measure, it is necessary to use Setting mode to set the phase wire system, VT / direct voltage, and CT primary current.
From Operation mode, move to Setting mode and then set necessary items. Factory default settings will be used for items
that you do not set.
Only the settings in Setting menu 1 (basic setting) are needed for normal use. For more information about the settings, refer
to page 15 and after.
For more information about the factory default settings, refer to the setting table on page 64.
CAUTION
Keep in mind that when a setting is changed, the related setting items and measurement data
will be reset to the default settings. (Refer to page 30.)
Measurement
Display
Setting Menu
End
End Display
CANCEL
Display
Automatic migration
Frequency
CT
current
VT/direct
voltage
Display
Pattern
Phase
wire system
MODBUS®RTU
address
MODBUS®RTU
baud rates
MODBUS®RTU
parity
MODBUS®RTU
stop bit
Active power
scale
Voltage scale
Current scale
Setting Menu
1
Setting Menu
2
Setting Menu
3
Cancel the settings
Save the setting
Power factor
scale
Instrument restart
or
Factory default setting
Operation Mode
※
2
※
1
Changes
Password
Password Protection Display
Example of Setting Mode
Example of Setting Value
Confirmation Mode
ON
Blinking
