16
z
Install with space around this unit
z
If this unit is installed in a place that is not level, or a place that is
unstable (on a carpet or tatami mat, etc.), it may vibrate.
z
The main unit is rotated by the automatic rotation, so
install with
20 cm or more of space around this unit
.
z
Before Installation
The air inlet, outlet, PM2.5 Sensor, and odor sensor are
located as shown in the figure on the right.
Take care regarding the following points.
Do not obstruct or place objects in front of the air inlet or outlet.
→
The air purification function will be impaired.
Do not obstruct the odor sensor.
→
It will not be possible to detect odors.
Do not obstruct the PM2.5 Sensor.
→
It will not be possible to detect dirt.
This unit cannot be used hanging from a wall.
Odor sensor
(inside inlet panel)
PM2.5 Sensor
Outlet
Inlet
Inlet
z
Installation Procedure
z
Install in a location with good air circulation.
z
Take care regarding the following points
during installation.
If installed facing an air-
conditioner, the circulation
effect is increased.
60 cm or more
20 cm or more
20 cm
or more
20 cm
or more
20 cm
or more
Do not place hot items such as a stove near
or on top of this unit.
This may cause
a malfunction,
deformation, or discoloration
.
Do not use in a place
subject to direct sunlight.
This may cause
deformation
or discoloration
.
Install this unit 1 m or more away from
television, cordless telephone, air
conditioners, personal computers,
fluorescent light fittings, etc.
This may cause
radio wave
interference
with the other
equipment.
Do not place on soil or sand.
Do not place on a floor with
much soil or sand.
This may cause
a malfunction
.
Installation
9. Installation Procedures
Note: This page is extracted from the full version instruction manual.
