─
18
─
Heater (PTC)
5
Remove the heater (PTC) with the heater fittings.
Assembly precautions
• Run the lead wires through the grooves of the blower cover.
(Indicated by
)
• Take care not to pinch the lead wires.
Heater fitting
Assembly precautions
• Run the heater lead wires as shown in the picture at right.
• Fit the thermal fuse parts into the grooves of the heater fittings.
(Indicated by
)
• Align the cable ties with the edge of the grooves. (Indicated by
)
Blower cover
(6) Blower assembly (Thermal fuse of the motor)
1
Remove the front panel.
→
See (2)
1
and
2
.
2
Disconnect the connectors (CN201 and CN202) from the control
circuit board.
→
See (2)
4
.
3
Disconnect the blower lead connectors (TAB3 and TAB4) from the
power circuit board.
→
See (4)
1
to
3
.
4
Push the cord bush into the blower cover. (Indicated by
)
Assembly precautions
• Attach the cord bush as shown in the picture at right.
• Make sure that there is no slack in the lead wires inside the blower
cover.
Cord bush
