─
14
─
10. Before receiving repair requests
Frequently asked question
Response
1 The hand dryer does
not blow air even
though hands are
inserted. (It may not
stop blowing air in
the case of
3
.)
The power light is not
turned on.
1
If the power wires are disconnected, securely connect
them to the terminal block.
2
If the circuit breaker is OFF, turn it ON.
Cases other than the
above
3
The sensor area may get dirt, clean up the sensor area.
2 The hand dryer does
not blow warm air.
( For JT-S2AP type)
The heater switch is
not turned on.
1
If the heater switch (SW1-2) is OFF, turn it ON.
Ambient temperature
is low.
2
When the room temperature is 18°C or lower, the hand
dryer, which is equipped with the simple heater, does not
blow sufficiently warm air.
3 Air blow is too weak to dry hands quickly.
1
If the air speed is set at STANDARD, switch it to HIGH.
2
If the filter is clogged, clean it up.
11. Service inspection list
Location
Inspection Item
Check Result
Electric wiring
Are lead wire connectors connected securely?
Is the wiring correct?
Operation
Does the hand dryer operate properly?
Isn’t there any abnormal noise, vibration, etc.?
Power light
Does the light (LED) come on?
Filter
Is the filter inserted into the proper position?
Wall installation
Isn’t there any gaps between the product and the back wall?