91
OCH714D
PHOTOS/FIGURES
DISASSEMBLY PROCEDURE
Photo 25-1
Photo 25-2
O-ring
Plastic
bag
Photo 25-4
Photo 25-5
Photo 25-6
Photo 25-3
Female
Male
O-ring
25. How to detach and attach the quick connection
Refer to the following steps when detaching and attaching the
quick connection.
(1) Remove the clip. (Photos 25-1 and 25-2)
(2) Separate the connected parts to remove the O-ring. (Photo 25-3)
• Do not reuse the removed O-ring.
• Wipe off if dirt or foreign matters are found on the sealing
surface where the O-ring touches.
(3) Apply grease on the O-ring using a plastic bag, etc. (Photo 25-4)
(4) Attach the O-ring to the male part of quick connection. (Photo 25-5)
• Keep the O-ring free from dirt or foreign matters.
(5) Connect the male and female parts of the quick connection.
(Photo 25-6)
(6) Attach the clip. (Photo 25-7)
•
Ensure to attach the wider diameter of the clip to the fe
-
male side. Failure to do so it may cause water leak at the
connected part. (Photo 25-8) (For the same diameter quick
connection, following this note is not necessary.)
Clip
Clip
Photo 25-8
Gap
Photo 25-7
Clip
