Mistral MKM2200, Instruction Manual

Page: 12 / 24

12
Note: if the bowl is not placed correctly
at position, a warning message will
appear on the display.
4. Put one of the accessories on the installed
shaft (25) (Fig.3).
•
Stir paddle (5)
•
Chop blade (6)
•
Steam basket (7).
Chop blade/stir blade:
when put them on the shaft, make sure it sits fully
at the bottom.
To remove them, lift its upward first, then turn it
clockwise or anticlockwise to remove it.
Whisk:
the whisk shall be placed onto the chop blade.
Put it onto the blade fully, then turn it clockwise
or anticlockwise to lock it
at position.
Warning: Never set the speed over “4”
when using the whisk.
Warning: The chop blades are sharp. Be
careful not to get hurt!
5. Make sure that the seal (3) is properly seated
in the bowl lid (2). It must be properly seated
in the groove for the seal around the entire
circumference.
6. Place the bowl lid (2) diagonally on the bowl
(8) as shown in Fig. 4, press it down and turn it
clockwise so that the handles of the bowl and
the lid overlap (the tabs in the lid will take
their places in the sockets of the bowl).
7. To remove the bowl from the appliance,
follow these steps:
a. Turn the bowl lid (1) slightly anticlockwise so
that the tabs in lid slides out of the sockets in
the bowl, carefully remove the lid from the
bowl.
b. Remove the bowl from the base of the
machine.
c. Remove the chop blade from the rotary shaft.
Caution: there is safety lock design, never
try to open the lid before the operation
completion. There is warning message on
the display.
Attention! The bowl may be disassembled
only when the lid is removed.
Preparation for Use
1. Unpack the appliance from the cardboard,
remove all bags, labels, cardboard and fillers.
Check the appliance for any damage that
may have occurred during transport. In case
of any doubts, please contact the seller.
2. Make sure that the parameters of your mains
supply correspond to the technical data on
the product rating plate.
3. Thoroughly wash and dry all parts in contact
with food following the instructions in the
section “Cleaning and Maintenance”.
4. Place the appliance on a dry, flat, stable and
horizontal surface.
5. The appliance has a safety system - it can
only be switched on if the bowl (8) and the
bowl lid (2) are correctly fitted.
Fitting/Removing the Bowl
Caution: Never run an incompletely
assembled appliance. Risk of injury!
1. Check that the seal is correctly fitted on the
drive shaft (25).
Drive shaft
seal
2. Insert the drive shaft (25) into the bowl so that
the sprocket goes through the hole in the
bottom of the bowl and then lock the drive
shaft by applying the lock (26) on it from the
outside and turning it slightly clockwise (Fig.1).
3. Place the bowl (8) on the base unit (11) with
the bowl’s handle side facing you so that
the pins at the bottom of the bowl adjust to
recesses in the base unit.