Mistral MKM2200, Instruction Manual

Page: 13 / 24

13
FITTING/REMOVING THE DEEP STEAMER
1. Follow the steps described in point 1-3 in the
section Fitting/Removing the Bowl.
2. Make sure that the seal (24) is properly seated
in the steamer container (23). It must evenly
adhere around its entire circumference to the
outside of the ring in the container.
3. Place the deep steamer (lower tray) (23)
diagonally on the bowl (8) as shown in Fig. 6,
and turn it clockwise so that the handles of
the bowl and the lid overlap (the tabs in the
lid will take their places in the sockets of the
bowl). Place the upper tray (22) on the lower
tray (23) and cover the lid (21).
4. To remove the deep steamer from the
appliance, follow these steps:
a. Remove the lid (21) and the upper tray (22).
b. Turn the lower tray (23) slightly anticlockwise
so that the tabs in the container slide out of
the sockets in the bowl, carefully remove the
lower tray from the bowl.
c. Remove the bowl from the base of the
machine.
FITTING/REMOVING THE GRATING/
SLICING DISC
1. Follow the steps described in point 1-3 in the
section FITTING/REMOVING THE BOWL. Install
the food processor pin(18) on the drive shaft
(25).
2. Place the grating/slicing disc (17) with the
appropriate side facing upwards on the
food processor pin(18), depending on the
operation (grating/slicing).
3. Make sure that the seal (16) is properly seated
in the Food processor lid (15). It must be
properly seated in the groove for the seal
around the entire circumference.
4. Place the Food processor lid (15) on the bowl
(8) as shown in Fig. 7, press it down and turn
it so that the handles of the bowl and the
lid overlap (the tabs in the lid will take their
places in the sockets of the bowl).
5. Place the pusher (14) in the Food processor
lid.
6. To remove the disc from the appliance, follow
these steps:
a. Turn the lid (15) slightly anticlockwise so that
the tabs in the lid slide out of the sockets in
the bowl, carefully remove the lid
b. Remove the bowl from the base of the
machine.
c. Remove the disc (17) from the food processor
pin(18).
d. Remove the food processor pin(18) from the
rotary shaft (25).
FITTING/REMOVING THE WHISK
1. Follow the steps described in point 1-3 in the
section FITTING/REMOVING THE BOWL.
2. Install chop blade (6) on the drive shaft (25)
inside the bowl, place the whisk onto the
blade, and turn it clockwise or anticlockwise
to lock it at position. The whisk shall (4) can be
used only with chop blade (6).
FITTING / REMOVING THE STEAM
BASKET
1. Follow the steps described in point 1-3 in the
section FITTING/REMOVING THE BOWL.
2. Pls install steam basket (7), (25) inside the
bowl.
FITTING / REMOVING THE STIR PADDLE
1. Follow the steps described in point 1-3 in the
section FITTING/REMOVING THE BOWL.
2. Pls install stir paddle (5) on the drive shaft (25)
inside the bowl.
MANUAL MODEL
HOW TO SET THE TEMPERATURE
Use finger touch the temperature field first,
(1) Then put finger on the temperature field, slide
the dial clockwise or anticlockwise to adjust
the temperature.
or
(2) Turn the control knob clockwise or
anticlockwise to adjust the temperature.