ENC-1103 SDI to Composite/CAV/RGB Encoder
Guide to Installation and Operation
ENC-1103
Page 7 of 19
Timing tab
These controls provide access to timing adjustments which affect
the signal outputs. There are three slider controls, each with a data
reporting box which shows the current value, and into which values
can be typed directly. If the Frame Sync option is not enabled,
only the Horizontal delay may be accessed.
VERTICAL: 0, 1, …, 523, 524 (for 525 operation), 623, 624 (for
625 operation):
sets the number of lines for vertical delay. This
control is available when the
Frame Sync option
has been
activated (see
Options
tab).
HORIZONTAL (µs): 69.7, 70, …, 132, 133.22 (for 525 operation),
133.7 (for 625 operation):
sets the horizontal delay in µs
.
HORIZONTAL FINE: -40, -39 …, 39, 40:
provides fine adjustment
for the horizontal delay
.
This control is available when the
Frame
Sync option
has been activated (see
Options
tab).
FRAME DELAY Pulldown box:
sets delay by frame steps: 0, 1, or
2 frames.
This control is available when the
Frame Sync option
has been activated (see
Options
tab).
Reference Input tab
These controls allow selection of the reference signal.
REFERENCE SOURCE:
Select between
AUTO
,
EXTERNAL
(use
the REF input signal connected to the rear panel),
URS
(see
below) or
INPUT
(use the input video signal as reference) as the
reference source. AUTO mode searches for available signal in this
order: REF input, URS and finally video input signal.
URS FORMAT: Select between OFF, 525 or 625 for the Universal
Reference Signal format
.
•
The URS is a multistandard audio/video reference
generated by an REF-1801 card, and distributed
internally to all cards in the Densité frame
•
The REF-1801 card must be installed in slot 10 of the
Densité frame
