26
Fault Diagnosis
Warning!
There are no user serviceable components beneath the cover of the Elite 2.
Only a competent tradesperson should remove the cover.
The trouble shooting information tabled below gives details on what you can do as a user
without removing the cover, should you encounter difficulties whilst operating the
shower.
Note!
Should these remedies prove to be unsuccessful in solving your problem, contact
your installer for advice.
Malfunction
Cause
Remedy
Elite 2 fails to operate
in any switch position.
Electrical supply isolated
at double pole switch ( the
pullcord).
Switch on electrical supply via
the pullcord.
Incoming water supply
stop valves or isolating
valve turned down or off.
Turn stop/isolating valve to
fully on position.
Hose or Handset blocked.
Clear blockage or renew.
No water or very low
flow rate.
Handset sprayplate
blocked.
Remove & clean: Refer to
Maintenance
in the I, O & M
guide for the fittings.
Section
11
Fault Diagnosis
(Continued)
Fuse blown or MCB/RCD
tripped indicating possible
electrical fault.
Renew the fuse or reset the
MCB/RCD. If fault persists,
contact your installer.
Possible blocked inlet filter
Clean or replace.
