44
988767UM REV A
• Content Subject to Change
AFTER USE DAILY TASKS
When you are
fi
nished using your RoboScrub 20, perform the following recommended daily tasks to clean and store the
RoboScrub 20.
DRAIN AND CLEAN TANKS, HOSES, AND FILTERS
1. Disengage all cleaning components by pressing the one-touch button, if needed. Doing so will raise the scrub
brush and squeegee, as well as turn off the vacuum motor.
2. Using appropriate personal protective equipment, drain the recovery tank using the recovery tank drain hose
located on the rear left of the RoboScrub 20.
3. Using appropriate personal protective equipment, clean out the recovery tank and its internal screened
fl
oat of
any remaining debris by
fl
ushing with water and/or wiping clean.
4. Using appropriate personal protective equipment, drain the solution tank using the solution tank site gauge/drain
hose located on the rear right of the RoboScrub 20.
5. Rinse the solution tank with clean water to prevent chemical buildup and clogging of water lines.
6. Remove the solution
fi
ll
fi
lter from the solution
fi
ll port on the rear, top left side of the RoboScrub 20 and rinse with
clean water.
CLEAN SCRUB BRUSH/PAD
1. Unload and remove the scrub brush or pad. See INSTALL SCRUB BRUSH/PAD on page 21 for details.
2. Remove any wire, string, or twine wrapped around the brush/pad.
3. Rinse with warm water.
4. Hang to dry.
CLEAN SQUEEGEE
Check the squeegee daily, and clean as necessary. Perform the following steps to clean:
1. Remove the squeegee: See INSTALL AND ADJUST SQUEEGEE on page 22 for details.
2. Rinse with warm water.
3.
Wipe
clean.
4.
Reinstall.