Minuit Une IVL PHOTON, Service Manual

Page: 41 / 63

IVL™ Photon Service Manual AA 41
1.3
Check whether on average the laser plane is
above or below the center / the bearing of
each tilt.
If it is above
– the adjustment will be done
by screwing in.
If it is below
– the adjustment will be made
by unscrewing.
Start screwing/unscrewing the screw in the
most off-center corner and adjust the height
of the plane until it is centered on the corner
of the 2 tilts.
Go to the next screw (
clockwise ) and
screw/unscrew until you are centered on
the tilts in the corner in question.
Always
check that the screw is well flattened, if this
is not the case, flatten it even if you are
already centered on the tilts.
Then move on to the next one always
clockwise .
Continue in this clockwise direction without
ever skipping screws or backtracking until all
directions of the laser plane are centered on
the tilts.
Check one last time that each screw is well
flattened and
tightened at the end of the
adjustment and put back the MT1-001600
screw covers on the tower.